|
Bicore
|
 |
| This is the PCB design for the standard bicore. It is similar to Mark Tildens Bc2 but with a few changes. Go here for more -- (coming soon) | |
 |
|
|
Hi-rez version
|
|
|
Actual size
|
|
H-Bridge motor driver
|
 |
| Dual h-bridges capable of driving two motors. Go here for more -- (coming soon) | |
 |
|
|
Hi-rez version
|
|
|
Actual size
|
|
Dual sensor board
|
 |
| Cool little PCB that has two spots for built in tactile sensors as well as all the circuitry to get you 2 motor walker backing up or 4 motor walker turning when your bot bumps an object. Go here for more -- (coming soon) | |
 |
|
|
Hi-rez version
|
|
|
Actual size
|
|
Complete walker
|
 |
| This is a PCB for the "almost complete walker" on my circuits page. It has everything you need to get your bot walking including.... Built in tactile sensor patch, motor circuitry, motor drivers and sensor circuit. Go here for more -- (coming soon) | |
 |
|
|
Hi-rez version
|
|
|
Actual size
|
|
1381 SE
|
 |
| Not much to say except I think you'll be happy with the design. Go here for more -- (coming soon) | |
 |
|
|
Hi-rez version
|
|
|
Actual size
|
|
FLED SE
|
 |
| Here's a PCB design for the old FLED SE. Good if you can't get a hold of the 1381 voltage detector. Go here for more -- (coming soon) | |
 |
|
|
Hi-rez version
|
|
|
Actual size
|
|
D1 SE
|
 |
| Fairly simple. Go here foe more -- (coming soon) | |
 |
|
|
Hi-rez version
|
|
|
Actual size
|
|
Battery charger
|
 |
| Very simple and will recharge your rechargeable batteries on your walker. You do use rechargeable don't you? Go here for more --- | |
 |
|
|
Hi-rez version
|
|
|
Actual size
|